View Single Post
Old May 3, 2019   #357
Worth1
Tomatovillian™
 
Worth1's Avatar
 
Join Date: Feb 2006
Location: Den of Drunken Fools
Posts: 38,539
Default

I'm finished.

I took the other plate I made, drilled two clearance holes for cap screws to connect to T nuts in the T slot.
Drilled and tapped 1/2 20 threads for the other bolts to connect to the plate.
Had to drill out smaller washers so they would have room to fit in the rotary table.
It was the easy way out, I could have made custom ones.
The apparatus sits on a cantilever of sorts and very ridged.
In last picture you will see one of my homemade T Nuts.
Worth1 is offline   Reply With Quote