Quote:
Originally Posted by Tomzhawaii
Yes, the quality in your work shows. It is painstaking work. But will last a few decades. My father made me a welding table in the 70's. My brother in law cherishes it. And it looks like the day it was made.
|
Thanks I try my best.
Here is a demonstration of it on it's back drilling 100 evenly spaced holes.
Cranking the handle clockwise and the sector arms counter clockwise.
Each time moving the handle 18 holes in the 20 hole section of the indexing plate.
Think sausage grinding plates
or just about anything you wanted.
Even cut ring grooves.
.
IMG_20190224_44408.jpg
Closeup of sector arms.
Here is where you would pull the pin rotate the handle clockwise and put the pin in the left sector arm.'
Drill hoke.
Then move the sector arm counter clockwise and repeat.
IMG_20190224_11604.jpg
IMG_20190224_2396.jpg