In the second picture you will see where the depth gauge is attached.
This is where I would like to mount the bracket.
The quill is MT 2 taper and the chuck is Jacobs 3 taper.
This is what they look like taken apart.
The chuck goes on the short side.
Any side thrust on these tapers will cause them to come out eventually.
The last thing I need is for the router to fall out running 20.000 RPM.
I have two routers one has a threaded body but only 1/4 shaft.
It is an old 1982 craftsman and hard to set up I just keep a rabbiting bit in it.
Again thank you.
Worth